Omni Vue Software

Omni Vue is software for viewing and analysing DICOM images that is in common use in many practices. Once you use the Spinalogic drawing and analysis system, you will have little use for the Omni Vue software except perhaps for special cases like measuring the Cobb angle in scoliosis.

You may want to send images stored in your Omni Vue system to Spinalogic. That is easy to do once configured.

What you need to do is set up Spinalogic as a destination to send to in your Omni Vue software. The settings for the Spinalogic receiver are:
AET: SPINALOGIC
IP: Your server static ip address
Port: 104

You then select whatever image or series you want to send and send to Spinalogic. They will appear in the Image Capture list.

It’s not to hard to set up in Omni Vue – check for DICOM send or DICOM destinations or something like that in the settings. If you get stuck, you may need to check with the Omni Vue documentation. You can find a copy of their manual below.

Manual

Orex Omni QC Manual